Difference between revisions of "Running Overload"
Jump to navigation
Jump to search
(Created page with "===Before test=== * Verify control is good by using taps or PWM to run motor, then verify control communicates to appropriate dev tool. * Fixture control on heat resistant sur...") |
(No difference)
|
Revision as of 17:31, 14 June 2021
Before test
- Verify control is good by using taps or PWM to run motor, then verify control communicates to appropriate dev tool.
- Fixture control on heat resistant surface with heatgun pointed at the power module heatsink from the outside.
- Set up oscilloscope with 3 amp clamps, one voltage probe, and degauss amp clamps.
- Recall test state "Running overload" via file menu.
